Eddy Current, and Ultrasonic techniques can be used to inspect bar and rod. The choice depends on the nonconforming conditions you wish to detect and the size and characteristics of the material. MAC instruments can handle a range of metal materials with a uniform cross section, including squares, rectangles, hex and round, in cut lengths or continuous production. Carbon steels, stainless alloys, aluminum, titanium and all other non ferrous metals can be inspected. Additional items such as markers, controls, demagnetizers, and components for mounting the encircling or segment test coils, saturation coils, rotaries, and for positioning and driving the material through the test, are combined with the instrumentation to make up a complete test system.

Short Surface & Subsurface Cracks
For detecting typical defects such as short surface and some subsurface cracks in carbon steel or non ferrous bar, a standard eddy current encircling coil instrument such as the MAC 175 or 400 is often selected. The MAC 175 can be supplied with a second test channel and the MAC 400 can be supplied with up to four test channels for applications that require greater capability. For the most demanding applications, the MultiMac"® provides optimum flaw discrimination with up to 8 test channels.

Internal Longitudinal and Transverse Flaws
When internal defects and inclusions need to be detected, ultrasonic inspection techniques are often the best choice. MAC's multi channel Echomac FD-4 instrumentation and the Echomac rotary transducer assembly, with its unique rotating seal-less water coupling system permits UT inspection at high throughput speeds. The FD-4 can also be utilized with squirter couplants and existing water immersion systems.

Long Continuous Surface Defects
For detecting long, continuous surface defects such as seams and laps in cold drawn wire or cut length bar stock, the MultiMac"® used with rotary probe sensors is the most appropriate. By rotating multiple test probes at speeds up to 6000 RPM around the bar or wire, even relatively short flaws can be reliably detected in many applications, without sacrificing throughput speed.

Both Short and Long Continuous Surface and Subsurface Defects
For those applications that require the detection of both short and long continuous surface or subsurface defects, the new MultiMac"® multi mode eddy current tester would be the right choice. The MultiMac with up to 8 test channels, allows simultaneous detection of both types of defects in magnetic or nonmagnetic material.

Alloy and Hardness Detection
Variations in alloy, heat treatment, case depth and hardness can be successfully detected by MAC's comparators. The Varimac® eddy current comparator can be used on a range of product types including non magnetic stainless bar. Variations in carbon steel or special alloy bar can also be detected with the Production Comparator low frequency electromagnetic comparator.

Combined Systems
For applications where more than one of the conditions described above must be met, a multiple test NDT system using several testers or technologies can be assembled. In these cases, each tester or technology is used to find the types of defects or conditions that it is best suited to detect. The result is often a more accurate test and fewer rejects to allow more of your product to be shipped to your customer.